Dell Networking S6000 System, Справочное руководство

Страница: 999 / 1510

NOTE: An interface can be attached only to a single OSPF area.
If you delete all the network area commands for Area 0, the
show ip ospf
command output does not list Area 0.
passive-interface
Suppress both receiving and sending routing updates on an interface.
S6000
Syntax
passive-interface {default | interface }
To enable both the receiving and sending routing, use the
no passive-
interface interface
command.
To return all OSPF interfaces (current and future) to active, use the
no passive-
interface default
command.
Parameters
default Enter the keyword
default
to make all OSPF interfaces
(current and future) passive.
interface Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For Port Channel groups, enter the keywords
port-
channel
then a number. For the C-Series and S-Series,
the range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Command
Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Open Shortest Path First (OSPFv2 and OSPFv3)
999