Dell Networking S6000 System, Справочное руководство

Страница: 607 / 1510

interface
interface
Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet
followed by the slot/port
information.
• For a Port Channel interface, enter the keyword
port-
channel
then a number. The range is from 1 to 128.
• For a 10–Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Defaults Disabled.
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
yield results. This command displays packets for IGMP and IGMP snooping.
ip igmp access-group
To specify access control for packets, use this feature.
S6000
Syntax
ip igmp access-group access-list
To remove the feature, use the
no ip igmp access-group access-list
command.
Internet Group Management Protocol (IGMP)
607