Dell Networking S6000 System, Справочное руководство

Страница: 890 / 1510

Related
Commands
• fefd disable — disables far-end failure detection on an interface.
• fefd reset — enables FEFD globally on the system.
• fefd mode — changes FEFD mode on an interface.
fefd disable
Disable FEFD on an interface only. This command overrides the
fefd reset
command for the interface.
Syntax
fefd disable
To re-enable FEFD on an interface, use the
no fefd disable
command.
Defaults Not configured.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Legacy E-
Series
command.
Usage
Information When you enter
no fefd
for an interface and fefd-global, FEFD is enabled on the
interface because the
no fefd
command is not retained in the configuration file.
To keep the interface FEFD disabled when the global configuration changes, use
the
fefd reset
command.
Related
Commands
• fefd reset — enables FEFD globally on the system.
• fefd mode — changes FEFD mode on an interface.
fefd interval
Set an interval between control packets.
Syntax
fefd interval seconds
To return to the default value, use the
no fefd interval
command.
890
Layer 2