Dell Networking S6000 System, Справочное руководство

Страница: 1006 / 1510

n]:
Dell#
router ospf
To configure an OSPF instance, enter ROUTER OSPF mode.
S6000
Syntax
router ospf process-id [vrf { vrf name }]
To clear an OSPF instance, use the
no router ospf process-id
command.
Parameters
process-id Enter a number for the OSPF instance. The range is from 1 to
65535.
vrf name (Optional) Enter the VRF process identifier to tie the OSPF
instance to the VRF. All network commands under this OSPF
instance are then tied to the VRF instance.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1(0.0) Added support for OSPFv3 on the S4810 and Z9000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.9.1.0 Added support for VRF.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information You must have an IP address assigned to an interface to enter ROUTER OSPF mode
and configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF
Process ID again in the system.
1006
Open Shortest Path First (OSPFv2 and OSPFv3)