Dell Networking S6000 System, Справочное руководство

Страница: 216 / 1510

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information
Dell Networking OS supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny Specify packets to reject
description List description
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Specify access-list entry remark
seq Sequence numbers
show Show Standard ACL configuration
permit
To forward packets from a specific source MAC address, configure a filter.
S6000
Syntax
permit {any | mac-source-address [ mac-source-address-mask ]}
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no permit {any | mac-source-address mac-source-
address-mask }
command.
Parameters
any Enter the keyword
any
to forward all packets received with a
MAC address.
mac-source-
address Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask (OPTIONAL) Specify which bits in the MAC address must
match. If no mask is specified, a mask of 00:00:00:00:00:00
is applied (in other words, the filter allows only MAC
addresses that match).
count (OPTIONAL) Enter the keyword
count
to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes
processed by the filter.
216
Access Control Lists (ACL)