Dell Networking S6000 System, Справочное руководство

Страница: 213 / 1510

Version 7.5.1.0 Introduced on the C-Series
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information The ACL hit counters in this command increment the counters for each matching
rule, not just the first matching rule.
Example
Dell#show mac accounting access-list mac-ext interface po 1
Extended mac access-list mac-ext on GigabitEthernet 0/11
seq 5 permit host 00:00:00:00:00:11 host 00:00:00:00:00:19
count (393794576 packets)
seq 10 deny host 00:00:00:00:00:21 host 00:00:00:00:00:29
count (89076777 packets)
seq 15 deny host 00:00:00:00:00:31 host 00:00:00:00:00:39
count (0 packets)
seq 20 deny host 00:00:00:00:00:41 host 00:00:00:00:00:49
count (0 packets)
seq 25 permit any any count (0 packets)
Extended mac access-list mac-ext on GigabitEthernet 0/12
seq 5 permit host 00:00:00:00:00:11 host 00:00:00:00:00:19
count (57589834 packets)
seq 10 deny host 00:00:00:00:00:21 host 00:00:00:00:00:29
count (393143077 packets)
seq 15 deny host 00:00:00:00:00:31 host 00:00:00:00:00:39
count (0 packets)
seq 20 deny host 00:00:00:00:00:41 host 00:00:00:00:00:49
count (0 packets)
seq 25 permit any any count (0 packets)
Dell#
Standard MAC ACL Commands
When you create an access control list without any rule and then apply it to an interface, the ACL
behavior reflects implicit permit. These commands configure standard MAC ACLs.
The S6000 support both Ingress and Egress MAC ACLs.
NOTE: For more information, also refer to the Commands Common to all ACL Types and Common
MAC Access List Commands sections.
deny
To drop packets with a the MAC address specified, configure a filter.
S6000
Syntax
deny {any | mac-source-address [ mac-source-address-mask ]}
[count [byte]] [log] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
Access Control Lists (ACL)
213