Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-249
Code
Problem Description
Troubleshooting
I9907
[Retract] When moving to the
PREFIRE position, PRS02 sensor
is light after trying it three times
but the light point cannot be found.
1. Open the BM3 moving path and
remove the media.
2. If the same fault continuously occur
after checking the device, replace the
PRT Module.
I9908
[Retract] When moving to the
CAPPING position, PRS02 sensor
is dark after trying it three times
but the dark point cannot be
found.
1. Open the BM3 moving path and
remove the media.
2. If the same fault continuously occur
after checking the device, replace the
PRT Module.
I9909
[Retract] When moving to the
CAPPING position, PRS02 sensor
is light after trying it three times
but the light point cannot be found.
1. Open the BM3 moving path and
remove the media.
2. If the same fault continuously occur
after checking the device, replace the
PRT Module.
I990A
[Retract]When moving to the
PREFIRE position and PRS02
sensor is dark, PRM01 motor
runs.
1. Open the BM3 moving path and
remove the media.
2. If the same fault continuously occur
after checking the device, replace the
PRT Module.
I990B
[Retract]When moving to the
CAPPING position and PRS02
sensor is dark, PRM01 motor
runs.
1. Open the BM3 moving path and
remove the media.
2. If the same fault continuously occur
after checking the device, replace the
PRT Module.
I99FF
[Retract]For PREFIRE, 10 or more
errors have occurred.
1. Open the BM3 moving path and
remove the media.
2. If the same fault continuously occur
after checking the device, replace the
PRT Module.
I9B01
[Retract]Jam at the BC entry
sensor (BCS01,BCS02).
1. Open the BC cover(3) and remove the
residual media and alien materials.
2. Check the BC Lock state.
I9B02
[Retract]Jam at the Align detection
sensor (AAS02).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I9B03
[Retract]Jam at the Align detection
sensor (AAS03).
1. Open the alignment(4) cover and
remove the residual media and alien
materials.
2. Initialize the device.
3. Check the alignment(4) cover lock
state.
I9B04
[Retract]Recog detection sensor
(RCS01) jam.
1. Remove the internal media and alien
materials in the Recognition(5).
2. Initialize the device.
3. If the same fault continuously occurs
after checking the device, replace the
Recognition(5) Module.