Nautilus Hyosung MX8800, Manual, Page: 531 / 827

Chapter2. Bill Recycling Machine (BRM) Error Code Manual
© 2014
Nautilus Hyosung Inc. All Rights Reserved.
2-527
Code Problem Description Troubleshooting
5T6P300 PP separate position transfer
error during Module Test. 1. Open the upper unit
2. Check the notes and substance
inside of the CSM
3. Check PP rotates softly using knob of
the CSM(1)
5T6P400 PP lose Return position
transfer error during Module
Test. 1. Open the upper unit
2. Check the notes and substance
inside of the CSM
3. Check PP rotates softly using knob of
the CSM(1)
5T6P500 PP notes out position transfer
error during Module Test. 1. Open the upper unit
2. Check the notes and substance
inside of the CSM
3. Check PP rotates softly using knob of
the CSM(1)
5T6P600 PP notes arrange error during
Module Test. 1. Open the upper unit
2. Check the notes and substance
inside of the CSM
3. Check PP rotates softly using knob of
the CSM(1)
5T6P700 PP separate control(during
separating) error during
Module Test. 1. Open the upper unit
2. Check the notes and substance
inside of the CSM
3. Check PP rotates softly using knob of
the CSM(1)
5T6P800 PP stack control(during
stacking) error during Module
Test. 1. Open the upper unit
2. Check the notes and substance
inside of the CSM
3. Check PP rotates softly using knob of
the CSM(1)
5T6P900 Error of reverting notes during
Module Test. 1. Open the upper unit
2. Check the notes and substance in the
CSM(2)
3. Check the knob rotates softly in the
CSM(2)
4. Check the knob rotates softly in the
CSM(3)
5T6PA00 PP preparation stop error
during Module Test. 1. Operate to initialize BRM(Recovery)
5TAE100 Received operation command
without Initial Info Set during
Module Test. 1. Restart over AP-SP
2. Do transation operation follow by set
up read system Info for TM Test-> Initail
Info Set -> Initialization
5TAE200 Status on not operation
receiption command during
Module Test. 1. Restart over AP-SP
2. Do transation operation follow by set
up read system Info for TM Test-> Initail
Info Set -> Initialization
5TAE400 Module Test transaction was
executed without Initializing
after power on . 1. Restart over AP-SP
2. Do transation operation follow by set
up read system Info for TM Test-> Initail
Info Set -> Initialization
5TAE600 Error to received Module Test
command. during TE Button
Operating. 1. Operate to initialize BRM(Recovery)
2. Reboot the system when same error
occurred (message timeout error) after
initialization