Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-67
Code
Problem Description
Troubleshooting
I3208
[Entry In/Out] Fault of causing
retry of moving the Cassette2
Push Plate Top position.
1. Check the arrangement state of the
banknotes in the Cassette2(15).
2. Check the stack position (CCS06) and
the media entry detection (CCS09) prism
state.
3. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15)
I3209
[Entry In/Out] Fault of exceeding
the retries when the Cassette2
Clamp failed to move to the
position (CCS08 Light).
1. Check the Cassette2 media guide
motor (CCM02) running and cable
connection.
2. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15).
I320A
[Entry In/Out] Fault that the home
position is not detected even when
the Cassette1 Clamp is running at
the home position (CCS08 Light).
1. Check the Cassette2 media guide
motor (CCM02) running and cable
connection.
2. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15)
I320B
[Entry In/Out] Failure to detect the
bottom (CCS05) when the
Cassette3 Push Plate Stack
moves.
1. Check the arrangement state of
banknotes in the Cassette.
2. Check the Stack position sensor
(CCS06) lever operation state.
3. If the Push Plate is not at the bottom,
check the alien materials at the
Cassette2 Bottom sensor(CCS05).
I3301
[Entry In/Out]Low-speed control
sensor fault.
1. Open the door at the Bundle side and
remove the residual media.
2. Check and remove the alien materials
in the Bundle low-speed wheel position
control (BDS14) sensor.
3. If no alien material exists, check
whether the sensor is polluted
4. Initialize the device.
I3302
[Entry In/Out]The delivering roller
with low-speed fails to operate
upward.
1. Check whether the Bundle low-speed
moving path (BDM02) is running.
2. Reboot the system when the same
error occurs.
3. Replace the motor and cables when
the same error occurs after checking the
device.
I3303
[Entry In/Out]The delivering roller
with low-speed fails to operate
downward.
1. Check whether the Bundle low-speed
moving path (BDM02) is running.
2. Reboot the system when the same
error occurs.
3. Replace the motor and cables when
the same error occurs after checking the
device.
I3304
[Entry In/Out]Shutter sensor fault.
1. Check and remove the alien materials
in the Bundle Shutter Open (BDS11)
and Close(BDS12) sensors.
2. If no alien material exists, check
whether the sensor is polluted