Chapter4. Cash & Check In Module Error Code Manual
© 2014
Nautilus Hyosung Inc.
All Rights Reserved.
4-99
Code
Problem Description
Troubleshooting
I4209
[Deposit Count/Check] Fault of
exceeding the retries when the
Cassette2 Clamp failed to move to
the position (CCS08 Light).
1. Check the Cassette2 media guide
motor (CCM02) running and cable
connection.
2. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15).
I420A
[Deposit Count/Check] Fault that
the home position is not detected
even when the Cassette2 Clamp
is running at the home position
(CCS08 Light).
1. Check the Cassette2 media guide
motor (CCM02) running and cable
connection.
2. If the same fault continuously occurs
after checking the device, replace the
Cassette2(15)
I420B
[Deposit Count/Check] Failure to
detect the bottom (CCS05) when
the Cassette2 Push Plate Stack
moves.
1. Check the arrangement state of
banknotes in the Cassette.
2. Check the Stack position sensor
(CCS06) lever operation state.
3. If the Push Plate is not at the bottom,
check the alien materials at the
Cassette2 Bottom sensor(CCS05).
I4212
[Deposit Count/Check]The request
number is 0 when checking the
deposit in Cassette2.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I4213
[Deposit Count/Check]The request
number exceeds 200 when
checking the deposit in Cassette2.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I4214
[Deposit Count/Check]The request
number does not exist when
checking the deposit in Cassette1.
1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I4301
[Deposit Count/Check]Low-speed
moving path sensor fault.
1. Open the door at the Bundle side and
remove the residual media.
2. Check and remove the alien materials
in the Bundle low-speed wheel position
control (BDS14) sensor.
3. If no alien material exists, check
whether the sensor is polluted.
4. Initialize the device.
I4302
[Deposit Count/Check]Low-speed
moving path up fault
1. Check whether the Bundle low-speed
moving path (BDM02) is running.
2. Reboot the system when the same
error occurs.
3. Replace the motor and cables when
the same error occurs after checking the
device.
I4303
[Deposit Count/Check]Low-speed
moving path down fault
1. Check whether the Bundle low-speed
moving path (BDM02) is running.
2. Reboot the system when the same
error occurs.
3. Replace the motor and cables when
the same error occurs after checking the
device.
I4304
[Deposit Count/Check]Shutter
sensor fault.
1. Check and remove the alien materials
in the Bundle Shutter Open (BDS11)
and Close(BDS12) sensors.
2. If no alien material exists, check
whether the sensor is polluted.
