Nautilus Hyosung MX8800, Manual, Page: 627 / 827

Error Code List Chapter4. Cash & Check In Module
4-74 © 2014 Nautilus Hyosung Inc. All Rights Reserved.
Code Problem Description Troubleshooting
I351B [Entry In/Out]Escrow output check
sensor (ESS04) jam when
outputting the media. 1. Open the Escrow Part(12).
2. Remove the ESS04 media and
pollution.
3. Execute CCIM initialization.
I351C [Entry In/Out]Residual media in
the Escrow (ESS01, ESS02) after
outputting the media. 1. Open the Escrow Part(12).
2. Remove the ESS01 and ESS02
media and pollution.
3. Execute CCIM initialization.
I3520 [Entry In/Out]For Escrow Drum
winding (50ms+2591Step), the
tape start is not light-detected for
50ms continuously, and a fault
occurs when 6s is exceeded. 1. Open the Escrow Part(12).
2. Remove the ESS06 media and
pollution.
3. Check Motor (ESM01)
4. Execute CCIM initialization.
I3521 [Entry In/Out]For Escrow Drum
winding (50ms+2591Step), the
Drum motor is not stopped and a
fault occurs when a timeout
occurs. 1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I3522 [Entry In/Out]For Escrow Drum
winding (50ms+5730Step), the
tape start is not light-detected for
50ms continuously, and a fault
occurs when 6s is exceeded. 1. Open the Escrow Part(12).
2. Remove the ESS06 media and
pollution.
3. Check Motor (ESM01)
4. Execute CCIM initialization.
I3523 [Entry In/Out]For Escrow Drum
winding (50ms+5730Step), the
Drum motor is not stopped and a
fault occurs when a timeout
occurs. 1. Execute CCIM initialization.
2. Reboot the system when the same
error occurs after initialization.
I3524 [Entry In/Out]Residual media at
the Escrow entry (ESS03, ESS04)
when detecting tape start (45s) by
unwinding the Escrow Drum 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I3525 [Entry In/Out]When rewinding the
Escrow Drum and detecting the
tape start (45s), the tape start is
not light-detected for 50 ms
continuously and if 45s is
exceeded, a fault occurs. 1. Open the Escrow Part(12).
2. Remove the ESS06 media and
pollution.
3. Check Motor (ESM01)
4. Execute CCIM initialization.
I3526 [Entry In/Out]Residual media at
the Escrow entry (ESS03, ESS04)
when detecting tape start
detection (2093Step) by
unwinding the Escrow Drum 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.
I3527 [Entry In/Out]Residual media at
the Escrow entry part (ESS03,
ESS04) when setting the tape end
position by winding the Escrow
Drum 1. Open the Escrow Part(12).
2. Remove the media at the Escrow
Drum residual check (ESS03) and
output check (ESS04) sensor part and
the pollution.
3. Execute CCIM initialization.