EURA SD20-G Series, Manual

Page: 86 / 353

SD20-G Series
86
V. Operation and parameters
5.1 Keypad description
5.1.1 Instruction of keypad
● ● ● ●
▲
MODE
▼
▲
Four operating buttons
Four buttons identifier
ALM
LCD Display
SON
Fig 5-1-1 Digital keypad
Identifier Name Function
SON
Charge LED
(green)
Indicating that Servo is on.
ALM
Charge LED
(red)
Indicating that malfunction occurs.
PANAL LCD Display
The LCD display (5-digit, 7-step display panel) shows the monitor codes,
parameter settings and operation values of the AC servo drive.
MODE Mode key
1 Switching between function groups.
2 Displaying malfunction codes in turn.
▲
（
UP
）
UP key
1 Pressing UP key to increase the display value.
2 Continuously pressing UP key for 0.5s to increase setting value slowly.
3 Continuously pressing UP key for 1s to increase setting value rapidly.
4 Used to forward start in jogging run.
▼
(DOWN)
DOWN key
1 Pressing DOWN key to decrease the display value.
2 Continuously pressing UP key for 0.5s to decrease setting value slowly. 3
Continuously pressing UP key for 1s to decrease setting value rapidly.
4 Used to reverse start in jogging run.
▲
（
SET
）
shift/set key
1 Continuously pressing this key for 0.5s to enter into parameter setting mode
2 Pressing this key can move the cursor to the left and then change
parameter settings (blinking digits) by using arrow keys.
3 Continuously pressing this key for 0.5s to confirm and set current value into
the parameter.
4 Continuously pressing this key for 2s to reset the malfunction.