SD20-G Series
56
For 380V servo drive
Manual power off Alarm relay
RLY normally
open contact
Contactor KM1
Normally open
contact
KM1
R/L1
S/L2
B2
B3
N
B1
QF circuit breaker
U
V
W
Three- phase AC
380 V power supply
*
PE
M
PG
ALM+
ALM-
+ 24V
0V
Alarm relay
RLY
CN1
CN2
CN3
Contactor
KM 1 coil
Manual power on
External resistor
Servo motor
PE
FIL filter
T/L3
Fig 4-1-5 Typical main circuit wiring of 380V servo drive
Note:
1. Built-in resistor is default and B2 and B3 terminal is short-circuit. If external resistor is used, please remove the
short cable between B2 and B3, and then connect external resistor between B1 and B2.
2. RLY
：
Alarm-signal output relay.
3. KM1: Contactor, connect or disconnect to main circuit power supply through manual switch.
4. N: DC bus.
Note: please connect an emergency stop circuit to main circuit so that servodrive can stop and power
off immediately in case accident occurs.
Summary of Contents for SD20-G Series
