EURA SD20-G Series, Manual

Page: 88 / 353

SD20-G Series
88
If fault occurs, current fault code will be displayed circularly.
5.2.2 Parameters instructions
The representation method in this manual is Po001.
The hollow digitron represents blinking operating digits, which is the adjustable digits.
☞
In this manual, three parameters modes is adopted to introduce the parameters.
☞ □□□□□
represents five operating digits in keypad.
■ one parameter mode (if no special instruction, the parameters belong to this mode)
□ □ □ □ □
one parameter mode means that five digits represent one parameter.
Q
For example:
Ex 1
：
Po113 internal speed given 1 is 1000r/min
，
the display content is:
（
The unit is 0.1 r/min
）
The quoting mode is Po113=1000.
Ex 2
：
Po114 internal speed given 2 is -1000r/min
，
the display content is:
（
The unit is 0.1 r/min
）
The quoting mode is Po114=-1000
。
Note: if all decimal points are lit, the current value is negative value.
■
Two parameters mode
d □ □□ □
Two parameters mode means every two digits except the first digit is an adjustable parameter digit.
Y X
X and Y represent an adjustable parameter digit separately.
For example:
Ex: Po407 CN3-5 terminal function is alarm-reset. The display content is:
The quoting mode is Po407.X=1.
■
Four parameters mode
b □□□□
Four parameters mode means each digit except the first digit is an adjustable parameter digit.
D C B A
A, B, C and D represent an adjustable parameter digit separately.
Ex: at position mode, the pulse command type of pulse+pulse is selected, then the last digit of Po300 is set to1.