SD20-G Series
197
6.5.6 Toreque Mode and Position Pulse Dual Mode
Internal register torque and position pulse command switching mode , external analog torque and
position pulsecommand switching mode shows as figure 6.5.5, after servo is enabled, servo runs as
position mode when mode switching signal is enabled; Servo runs as torque mode when mode switching
signal is disabled.
In the running process of torque mode, servo slows down to zero according to deceleration time when
mode switching signal is enabled; servo cannot receive position pulse signal until switching to position
pulse mode after position reach signal output is enabled.
In the running process of position pulse mode, when mode switching signal is disabled, servo switches to
torque mode Immediate and run to target torque according to acceleration/deceleration time.
Torque
Curve
Position Reach
Output
Position Pulse
Input
Mode Switch
Torque Set
switching
Torque Set
Pulse
receiving
Fig 6.5.5 Torque mode and position pulse mode sequence diagram
Summary of Contents for SD20-G Series
