22
3. Check the IQDM jack on the speed controller.
3.1. Remove the two screws securing the rear body access panel and remove the access panel.
3.2. Remove the two screws (5) securing the controller cover (1) to the component mounting plate
(Figure 22-10, Page 22-20)
.
3.3. Disconnect the square four-pin connector (3) from the speed controller.
3.4. Connect the handset cord to the handset.
3.5. Connect the other end of the handset cord (without the adapter) (4) to the four-pin connector of the
speed controller (2)
(Figure 22-10, Page 22-20)
.
3.6. Connect the vehicle batteries, positive (+) cable first.
3.7. If the handset functions when connected directly to the speed controller, the adapter plug or vehicle
wire harness should be thoroughly tested.
See Test Procedure 2 – Handset Cord Adaptor on
page 22-18. See also Section 21 – Electrical System and Testing: Electric Vehicle
Figure 22-10 IQ System Component Mounting Plate
4
2
3
1
5
Summary of Contents for 2007 XRT 800
