MOTOR (MODEL 5BC59JBS6390)
Motor Speed Sensor
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 26-15
26
MOTOR SPEED SENSOR
See General Warning on page 1-1.
Testing the Motor Speed Sensor
See Test Procedure 13, Section 21, Page 21-29.
Motor Speed Sensor Removal
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Disconnect the three-pin connector (22) from the vehicle wire harness
(Figure 26-19, Page 26-15)
.
3. Using a screwdriver, gently pry the motor speed sensor (21) from recessed area on the motor end shield.
Motor Speed Sensor Installation
1. Position the motor speed sensor (21) as shown and firmly press the speed sensor into the motor end
shield. Sensor should fit flush against the motor
(Figure 26-19, Page 26-15)
.
2. Connect the three-pin connector (22) to the vehicle wire harness.
3. Place the Tow/Run switch in the TOW position and connect the batteries, positive (+) cable first. Tighten
battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray (CCI
P/N 1014305) to minimize corrosion.
Figure 26-19 Motor Speed Sensor
21
22
Summary of Contents for 2007 XRT 800
