IQ DISPLAY MODULE (IQDM) AND IQDM-P DIAGNOSTICS
Functions Menu
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 22-13
22
6. Select
settings
.
7. Select
write settings to controller
.
8. Press + on the change value button to confirm the operation.
9. The handset will display an “executing...” message for the next few seconds while the controller settings
are being stored in the handset’s memory
(Figure 22-4, Page 22-12)
.
10. When the handset is finished transferring the speed controller settings, a confirmation message is dis-
played
(Figure 22-6, Page 22-13)
.
11. Repeat this procedure for additional vehicles that need to be programmed with the same handset set-
tings.
RESET ALL SETTINGS
In the event that a mistake was made and one or more changes should not have been made with the handset,
the speed controller settings can be reverted to the original settings from the beginning of the session (when
the handset was plugged into the vehicle). This function is similar to the “undo” command on a PC and will
work correctly only when the handset has
not
been unplugged and power to the speed controller has
not
been interrupted.
Figure 22-6 Confirmation Message
Figure 22-7 Confirmation Message
All Controller Settings
Set from Programmer.
OK (+)
OK (+)
2
3
1
All Controller Settings
Reset to Original Values.
OK (+)
OK (+)
2
3
1
Summary of Contents for 2007 XRT 800
