Club Car 2007 XRT 800, Maintenance Service Manual

Page: 77 / 516

WHEEL BRAKE ASSEMBLIES Brake Shoe Installation
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual Page 6-7
6
4. While maintaining spring attachment on both shoes, position tips of leading shoe in the mounting slots
and then push shoe into place. Hold shoe in position and install retaining clip (Figure 6-15, Page 6-7) .
5. After the shoes are installed, move them together up and down and side to side to make sure that they
will easily slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding (Figure 6-16, Page 6-7) .
6. Place a flatblade screwdriver under the adjusting arm and raise the arm off of the adjusting wheel. While
holding the arm up, turn the wheel upward until it stops (Figure 6-17, Page 6-7) . Remove the screw-
driver.
7. Install the axle shaft (2) into the axle tube and install the retaining ring (1) (Figure 6-2, Page 6-2) . See
following WARNING and CAUTION.
ý
WARNING
• Be sure retaining ring is properly seated in groove. If ring is not properly installed, the axle
assembly will separate from the transaxle and damage the axle assembly and other
components. Loss of control of the vehicle could result in severe personal injury or death.
Figure 6-15 Install Leading Shoe Figure 6-16 Check Shoe Positions
Figure 6-17 Set Adjusting Wheel
LEADING SHOE
TRAILING
SHOE
FR
ON
T O
F
VE
HIC
LE
B
A
ADJUSTING
WHEEL
ADJUSTING
ARM