![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829428.webp)
ELECTRICAL COMPONENTS: ELECTRIC VEHICLE
Tow/Run Switch
Page 23-8
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
23
MOTOR CONTROLLER OUTPUT REGULATOR (MCOR)
See General Warning on page 1-1.
Testing the MCOR
See Section 21, Test Procedure 4, Page 21-10 and Test Procedure 8, Page 21-16.
MCOR Removal
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Place chocks at rear wheels and lift the front of the vehicle with a chain hoist or floor jack. Place jack
stands under the round tube crossmember of the frame to support vehicle.
See WARNING “Lift only
one end...” in General Warning on page 1-1.
3. Disconnect the two-pin and three-pin connectors (1) from the MCOR (2)
(Figure 23-7, Page 23-8)
.
4. Remove the hex-head screws (3) connecting the MCOR to the frame I-beam.
5. Remove the MCOR from vehicle.
6. Push the drive bar (4) into the hole in the I-beam to disengage it from the accelerator pivot rod (5).
Figure 23-7 Motor Controller Output Regulator (MCOR) Mounting
G
O
3
4
5
1
2
Summary of Contents for 2007 XRT 800
