ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE
Oil Level Sensor
Page 14-26
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
14
17. Secure the wire harness to the stiffener with a wire tie. Place the wire tie through the lower hole at the
back of the stiffener
(Figure 14-24, Page 14-24)
.
ý
CAUTION
• Make sure wire harness is routed and secured away from the muffler.
18. Install the muffler.
See Muffler Installation on page 17-1.
19. Connect the spark plug wire to the spark plug.
20. Connect battery cables, positive (+) cable first, and tighten hardware to 144 in-lb (16 N·m)
(Figure 1-1,
Page 1-3)
. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corro-
sion.
OIL LEVEL SENSOR
See General Warning on page 1-1.
Testing the Oil Level Sensor
See Test Procedure 22 – Oil Level Sensor on page 12-29.
Oil Level Sensor Removal
See Oil Level Sensor Removal on page 15-5.
Oil Level Sensor Installation
See Oil Level Sensor Installation on page 15-5.
HEADLIGHTS
See General Warning on page 1-1.
Testing the Headlight Socket
See Test Procedure 30 – Voltage at Headlight Socket on page 12-35.
Headlight Bulb Removal
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. From the front of vehicle, reach under cowl and turn the wire harness/halogen bulb assembly, (4 and 6),
clockwise one-quarter turn
(Figure 14-29, Page 14-27)
.
3. Remove the wire harness/halogen bulb assembly (4 and 6) from the headlight lens (7).
4. Lift the retaining tabs on the connector (4) and remove halogen bulb assembly (6).
Summary of Contents for 2007 XRT 800
