![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829238.webp)
ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE
Starter/Generator
Page 14-6
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
14
Field Coil Removal
1. Remove the retaining nut from each field coil terminal and slide the insulator out of the slots in the hous-
ing. Remove the four pole piece screws from the housing. Remove the four pole pieces from inside the
housing. Remove the field coils from the inside of the housing
(Figure 14-10, Page 14-6)
.
See following
NOTE.
NOTE:
Do not remove the insulators or the field coils unless an electrical test indicates that it is necessary
(Figure 14-10, Page 14-6)
.
See Test Procedure 8 – Starter/Generator (Starter Function) on
page 12-16.
Visual Inspection of Armature
Obvious defects can be seen by examining the armature. If an armature has frayed or charred insulation, bro-
ken wires or thrown solder, it is obvious without testing that it should be replaced. Faults seen during the
visual inspection can aid in diagnosing the original cause of the failure. Items to look for are listed below.
•
Burned, charred, or cracked insulation
•
Improperly cured varnish
•
Thrown solder
•
Flared armature windings
•
Worn, burned, or glazed commutator
•
Loose or raised commutator bars
•
Bruised or damaged armature core laminations
•
Worn armature bearing or shaft
•
Dirty or oily commutator
Figure 14-10 Field Coil Assembly
RETAINING NUT
INSULATOR
FIELD COIL
TERMINAL
HOUSING
FIELD COIL
POLE PIECE SCREW
POLE PIECE
Summary of Contents for 2007 XRT 800
