STEERING AND FRONT SUSPENSION
Rack and Pinion
Page 7-8
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
7
6. Remove the rack screw lock nut (15), rack guide screw (16), rack guide pressure spring (14), and the
rack guide (13).
7. Remove the universal joint assembly from the pinion (8) by fully removing the bolt and then sliding off the
universal joint.
8. If necessary, remove the dust seal (12)
.
See following NOTE.
NOTE:
If the dust seal (12) is removed, replace with a new one
(Figure 7-8, Page 7-8)
.
9. Using snap ring pliers, remove the internal snap ring (11)
(Figure 7-8, Page 7-8).
10. Install the universal joint onto the pinion and place a large open end wrench under the universal joint
(Figure 7-9, Page 7-9)
. Use the wrench as a lever to pull the pinion from the housing.
Figure 7-8 Steering Gear
TYPICAL
3 PLACES
TYPICAL
3 PLACES
17
18
19
20
32
6
13
8
7
9
12
4
3
2
1
29
28
27
23
24
26
33
25
22
11
10
14
15
16
31
30
21
2
Summary of Contents for 2007 XRT 800
