ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES
Starter/Generator
Page 13-10
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
13
6. Install the white wire from the solenoid to the F2 terminal on the starter/generator. Install the black wire
from the frame to the A2 terminal on the starter/generator. Install a flat washer, lockwasher and nut onto
each terminal, and tighten the nut to 48 in-lb (5.4 N·m).
7. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Belt Tension Adjustment
Belt tension should be checked periodically. If the belt slips when starter/generator motor operates, adjust belt
to correct tension.
1. Turn the key switch is OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL
position. Chock the wheels.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Make sure the two pivot bolts (5) on the mounting bracket, carriage bolt (11) and hex nut (12) are finger-
tight
(Figure 13-13, Page 13-10)
.
4. Push the starter/generator down to its lowest point of adjustment travel. With the starter/generator belt
in place around the drive clutch pulley, install the starter/generator belt (3).
5. Place a pry bar (13) between the top of the starter/generator mounting bracket (2) and the underside of
the starter/generator, by passing the pry bar under the exhaust header.
6. Hold the pry bar and measure the belt tension using a Krikit
®
gauge (1) (available at NAPA
®
Auto Parts
stores), or equivalent. Proper tension for a new starter/generator belt should be 75 ft-lb (101.7 N·m), or
45 ft-lb (61 N·m) for an existing belt
(Figure 13-14, Page 13-10)
.
7. While maintaining the tension, tighten the adjustment nut (12) to 144 in-lb (16.3 N·m). Tighten the two
pivot bolts (5) and hex nuts (7) to 23 ft-lb (31.2 N·m)
(Figure 13-13, Page 13-10). See following CAU-
TION.
ý
CAUTION
• Remove pry bar before starting engine.
8. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Figure 13-13 Starter/Generator Assembly
Figure 13-14 Belt Tension Gauge
13
7
5
TYPICAL
2 PLACES
2
3
10
4
11
1
9
12
END VIEW
1
Summary of Contents for 2007 XRT 800
