MOTOR (MODEL 5BC59JBS6390)
Motor
Page 26-4
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
26
Motor Disassembly
1. Before beginning disassembly, place match marks on the motor end shield and stator shell, then place
the motor in a vice with wooden blocks as shown
(Figure 26-4, Page 26-4)
.
2. Remove the four bolts (8) securing the end shield (10) to the stator shell (2).
3. Remove the two screws (9) attaching the end shield to the bearing retainer.
4. Slide the armature (17) out of the opposite end of the stator shell (2).
5. Remove two screws (11) attaching brush rigging (12) to the stator shell (2)
(Figure 26-9, Page 26-8)
.
6. Mark the brush terminal posts (A1 and A2) (13) to identify their positions in the stator shell, then remove
the nuts (6) and flat washers (5)
(Figure 26-9, Page 26-8)
. From the outside, push the posts through the
stator shell wall into the interior of the stator shell.
7. Carefully remove the brush rigging and the terminal posts from the stator shell.
8. To remove brush springs (14)
from the rigging, lift the spring extensions out and over the brush mounts
and then slide the springs off their mounting tabs
(Figure 26-5, Page 26-4)
.
Figure 26-4 Motor Disassembly
Figure 26-5 Brush Spring Removal
F2
A2
8
10
2
MATCH
MARKS
ARMATURE
17
9
14
Summary of Contents for 2007 XRT 800
