ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE
Neutral Lockout Limit Switch
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 14-17
14
Neutral Lockout Limit Switch Installation
1. Install the neutral lockout limit switch with two washers and two nuts
(Figure 14-18, Page 14-17)
.
Tighten to 5 in-lb (0.6 N·m). Place the Forward/Reverse handle in REVERSE to make sure that both
switches actuate.
See following CAUTION.
ý
CAUTION
• Do not overtighten the retaining nuts. If the nuts are overtightened, limit switches could be
damaged.
2. Connect wires to neutral lockout limit switch:
•
Connect the black/light blue wire to common (COM) terminal, the tan wire to the normally open (NO)
terminal and the gray wire to the normally closed (NC) terminal of the neutral lockout limit switch.
See
Wiring Diagram on page 12-6.
3. Connect battery cables, positive (+) cable first, and tighten hardware to 144 in-lb (16 N·m)
(Figure 1-1,
Page 1-3)
. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corro-
sion.
4. Check limit switch operation.
•
Place the Forward/Reverse handle in the NEUTRAL position. The neutral lockout switch should be in
the OPERATE position. Make sure everyone is clear of the vehicle. Turn the key switch to the ON posi-
tion. The engine should not crank when pressing the accelerator. If the engine does crank, turn the key
switch OFF and readjust the shift linkage.
5. Test drive the vehicle in both forward and reverse to check for proper operation.
Figure 14-18 Neutral Lockout, Reverse Buzzer and
Starter Solenoid Limit Switches
Figure 14-19 Removal of Limit Switches
Summary of Contents for 2007 XRT 800
