![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829222.webp)
ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES
Ignition Coil
Page 13-24
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
13
IGNITION COIL
See General Warning on page 1-1.
The ignition coil is located under the flywheel shroud of the engine. To replace it requires the removal and
installation of the engine and transaxle. It is recommended that the ignition coil be thoroughly tested prior to
replacement.
Testing the Ignition Coil
See Test Procedure 14, Section 11, Page 11-22. Also see Test Procedure 15 – RPM Limiter on
page 11-23 and Test Procedure 16 – Ignition Coil on page 11-23.
Ignition Coil Removal
Removing the ignition coil requires the removal of the engine and unitized transaxle.
See Unitized Transaxle
Removal, Section 18, Page 18-6.
See following CAUTION.
CAUT ION
• Before removal and disassembly, clean the engine.
1. Remove the starter/generator.
See Starter/Generator Removal on page 13-1.
See following NOTE.
NOTE:
The crankshaft has left-hand threads at the clutch mounting hole.
2. Remove the muffler.
See Muffler Removal, Section 17, Page 17-1.
3. Remove the engine mounting hardware (items 1, 2, and 5)
(Figure 15-4, Page 15-4)
.
4. Remove the two nuts (6) and washers (3) from the stud bolts on the engine body.
5. Slide the engine away from the transaxle housing and lift the engine from the mounting plate.
6. Place the engine on a solid, flat surface, preferably on a sturdy work bench.
7. Remove the pan head bolts (5) securing the fan shroud (8) to the fan housing (9)
(Figure 13-24,
Page 13-25)
.
8. Loosen, but do not remove, three bolts (6) attaching the fan housing as shown.
9. Remove the remaining four bolts (10) attaching the fan housing
(Figure 13-24, Page 13-25)
, then while
opening the housing, detach the spark plug wire grommet (4) from the housing
(Figure 13-26,
Page 13-26)
.
10. Disconnect the 18-gauge black wire (12) from the spade terminal (13) on the ignition coil (11) and remove
the coil by removing two bolts (10)
(Figure 13-25, Page 13-25)
.
Summary of Contents for 2007 XRT 800
