![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829214.webp)
ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES
Fuse
Page 13-16
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
13
Solenoid Installation
1. Install the solenoid in the electrical component box using two screws to secure the solenoid to the box
and tighten to 14 in-lb (1.6 N·m).
See following WARNING.
ý
WARNING
• Incorrect wiring could result in severe injury or death.
• Diode and solenoid connections must have correct polarity.
• Keep all persons clear of engine belts when making final connections.
2. Connect all wires as indicated.
2.1. Connect the 6-gauge white wire from the starter/generator, 18-gauge red wire from the voltage reg-
ulator, and the 12-gauge white wire from the diode to the large post on the solenoid.
See Wiring
Diagrams, Section 11, Page 11-6.
2.2. Connect the 6-gauge red wire from the battery, the 10-gauge red wire from the fuse block, and the
12-gauge red wire from the diode to the other large post on the solenoid.
2.3. Connect the 18-gauge blue wire from the key switch to the small post on the solenoid.
2.4. Connect the 18-gauge green wire from the Forward/Reverse limit switch to the other small post on
the solenoid.
3. Tighten the hex nuts on the large solenoid posts to 55 in-lb (6.2 N·m). Tighten the nuts on the small sole-
noid posts to 22 in-lb (2.5 N·m).
4. Install the snap-on electrical box cover by firmly pressing down on all corners and install the screw and
tighten to 18 in-lb (2 N·m).
5. Install the air intake hose onto the carburetor.
6. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
FUSE
See General Warning on page 1-1.
Testing the Fuse
See Test Procedure 2, Section 11, Page 11-11.
Fuse Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Remove the air intake hose from the carburetor.
4. Remove electrical component box cover.
5. Remove the fuse from the fuse block.
Fuse Installation
1. Install the fuse.
See following WARNING.
Summary of Contents for 2007 XRT 800
