Club Car 2007 XRT 800, Maintenance Service Manual

Page: 329 / 516

UNITIZED TRANSAXLE: 850 GASOLINE VEHICLE Axle Shaft
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual Page 19-3
19
8. Position a 16-inch (40 cm) rolling head prybar (Figure 19-4, Page 19-3) under the inside lip of the seal
and pull the oil seal out (Figure 19-5, Page 19-3) . See following CAUTION.
ý
CAUTION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal. A damaged
tube might have to be replaced.
9. Inspect the axle shaft assembly to be sure the bearing (71) and collar (73) have not slipped and are still
seated against the shoulder on the axle shaft (Figure 19-6, Page 19-4) .
10. Inspect the bearing. If the bearing is damaged or worn, replace it.
AXLE BEARING
Axle Bearing Removal
1. Use external retaining ring pliers (0.047-inch tip) to remove the retaining ring (74). Place a bearing puller
wedge attachment (CCI P/N 1012812) on the axle shaft between the wheel mounting flange and the
bearing
(Figure 19-6, Page 19-4) . See also Figure 19-7, Page 19-6 . See following CAUTION.
Figure 19-3 Retaining Ring
Figure 19-4 Rolling Head Prybar Figure 19-5 Seal Lip
1
2