ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES
Diode
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 13-13
13
CAUT ION
• Be sure to remove and discard the protective film from both sides of the thermal pad before
installing it. If not removed, the film will reduce the thermal heat transfer and therefore reduce
the power handling capability of the diode, causing it to overheat and damage the electrical
system.
3. Mount the diode (2) using the thermal transfer pad (1) and mounting nut (3) and tighten to 25 in-lb (2.8
N·m)
(Figure 13-16, Page 13-13)
.
See following NOTE.
NOTE:
Diodes are mounted in one of two different locations, depending on the vehicle model
(Figure 13-16, Page 13-13)
.
4. Route and connect the red and white diode wires to the solenoid posts in the electrical component box.
See following WARNING.
ý
WARNING
• Incorrect wiring could result in severe injury or death.
• Diode and solenoid connections must have correct polarity.
• Keep all persons clear of engine belts when making final connections.
Figure 13-16 Electrical Component Box and Diode Orientation
OUTER
I-BEAM
5
7
6
WHITE FROM
DIODE
RED FROM
BATTERY
RED FROM
DIODE
RED FROM
VOLTAGE
REGULATOR
RED FROM
FUSE BLOCK
Some wires
omitted
for clarity.
WHITE FROM
STARTER/
GENERATOR
2
1
3
VIEWED FROM INSIDE
DRIVER SIDE FRAME
Summary of Contents for 2007 XRT 800
