TRANSAXLE (TYPE G): ELECTRIC VEHICLE
Transaxle
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 28-5
28
TRANSAXLE
See General Warning on page 1-1.
TRANSAXLE REMOVAL
1. Place chocks at the front wheels and slightly loosen lug nuts on both rear wheels.
2. Place a floor jack under the transaxle and raise the rear of the vehicle. Position jack stands under the
frame crossmember between the spring mount and the side stringer, just forward of each rear wheel.
Lower the vehicle to let the jack stands support the vehicle
(Figure 28-6, Page 28-5)
.
See WARNING
“Lift only one end of the vehicle...” in General Warning on page 1-1.
3. Remove the rear wheels, then thread one lug nut onto a stud on each rear hub. This will keep the brake
drums on the hubs.
4. Remove the bow-tie pins (1), brake cable clevis pins (2), and cable retaining E-clips (3). Disconnect the
brake cables (4)
(Figure 28-7, Page 28-5)
.
Figure 28-6 Vehicle Supported on Jack Stands
Figure 28-7 Disconnect Brakes
Figure 28-8 Disconnect Shocks
Figure 28-9 Shackles
1
2
4
3
Remove bolts, then
rotate shackles up
and away from spring.
Summary of Contents for 2007 XRT 800
