WHEEL BRAKE ASSEMBLIES
Brake Shoe Removal
Page 6-2
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
6
5.2. Insert a 1/2 inch x 5/8 inch cold chisel under the head of each pin and shear them off as illustrated
(Figure 6-3, Page 6-2)
. This will release the shoes from the backing plate, allowing them to pivot
away from the inside of the brake drum, which should then allow the brake drum to be pulled free.
After completing step 6, skip step 7.
See following NOTE.
NOTE:
Although step 6 allows easier access to the brake shoes, it is not imperative to do so in order to
remove the brake shoes.
6. Remove the axle.
6.1. Using 90° snap ring pliers (CCI P/N 1012560), remove the axle retaining ring (1)
(Figure 6-2,
Page 6-2)
.
6.2. Pull the axle shaft (2) from the axle tube
(Figure 6-2, Page 6-2)
.
Figure 6-1 Loosen Equalizer Retaining Nuts
Figure 6-2 Remove Axle Retaining Ring
Figure 6-3 Shoe Retainer Pins
1
2
3
1
2
BRAKE
DRUM
AXLE TUBE
1/2 IN. X 5/8 IN. COLD CHISEL
TWO BRAKE SHOE
RETAINER PIN
HEADS
Summary of Contents for 2007 XRT 800
