ELECTRICAL COMPONENTS: ELECTRIC VEHICLE
Charger Receptacle
Page 23-16
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
23
RECEPTACLE FUSE LINK
The fuse link on the 48-volt electric vehicle should not blow under normal operating conditions; however, if the
fuse link has blown, the vehicle will not charge and the fuse must be replaced. The fuse link (6) is mounted on
top of the charger receptacle in the battery compartment
(Figure 23-14, Page 23-16)
.
Receptacle Fuse Link Removal
1. Remove the fuse link (6) from the charger receptacle (7) by removing the two nuts and washers used to
secure the 10-gauge black wire (5) from the computer and the 10-gauge black wire to the receptacle
(Figure 23-14, Page 23-16)
.
2. Remove the fuse link (6) from the charger receptacle.
Receptacle Fuse Link Installation
1. Insert the two fuse link mounting posts into the mounting holes in the charger receptacle.
2. Place the two 10-gauge black wires in their original positions on the fuse link mounting posts. Tighten to
23 in-lb (2.6 N·m).
3. Install nuts (2) on fuse link mounting posts and tighten to 23 in-lb (2.6 N·m)
(Figure 23-14, Page 23-16)
.
Figure 23-14 Charger Receptacle
5
7
1
6
11
8
4
3
9
2
TYPICAL
2 PLACES
Summary of Contents for 2007 XRT 800
