Club Car 2007 XRT 800, Maintenance Service Manual

Page: 260 / 516

ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE Voltage Limiter
Page 14-28 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
14
VOLTAGE LIMITER
See General Warning on page 1-1.
Testing the Voltage Limiter
See Test Procedure 29, Section 12, Page 12-35.
Voltage Limiter Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Remove the instrument panel. See Key Switch Removal on page 14-12.
4. Disconnect wires from the voltage limiter (1). Do not allow wires to touch (Figure 14-30, Page 14-28) .
NOTE: Identify terminal for solid black wire and terminal for black/white wire.
5. Remove the mounting hardware (2) from the voltage limiter and remove it from the vehicle.
Voltage Limiter Installation
1. Mount the voltage limiter to the frame using the mounting hardware and tighten to 25 in-lb (2.8 N·m)
(Figure 14-30, Page 14-28) .
2. Connect the black/white wire from harness to the negative (–) terminal on the diode.
3. Connect the solid black wire from the ground terminal block to the positive (+) terminal on the diode.
4. Install the dash panel in reverse order of removal.
See Key Switch Removal on page 14-12.
5. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Figure 14-30 Voltage Limiter Figure 14-31 Light Switch
1
2
SET SCREW
3
4
1
2