![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829189.webp)
TROUBLESHOOTING AND ELECTRICAL SYSTEM: 850 GAS
Test Procedures
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 12-27
12
TEST PROCEDURE 16 – KILL LIMIT SWITCH
See General Warning on page 1-1.
The kill limit switch is located inside the electrical component box. The accelerator kill switch is the lower of
the two limit switches and has a white/black wire and black wire connected to it.
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Check for proper wiring and tight connections.
3. Disconnect the wires from the limit switch and test the limit switch for continuity.
•
Place the red (+) probe of the multimeter on the common (COM) terminal (white/black wire) of the limit
switch. Place the black (–) probe on the normally open (NO) terminal (black wire) of the limit switch.
Without the lever pressed, the reading should be no continuity. Press the lever, and the reading should
be continuity. If either reading is incorrect, replace the limit switch
(Figure 12-28, Page 12-27)
.
4. Connect wires to limit switch and check for tight connections.
TEST PROCEDURE 17 – KEY SWITCH (ENGINE KILL CIRCUIT)
See General Warning on page 1-1.
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Remove the center dash assembly.
See Key Switch Removal on page 14-12.
3. Disconnect wires from the (+M) and (–M) terminals of the key switch.
4. Place the red (+) probe on the (+M) terminal and the black (–) probe on the (–M) terminal. With the key
switch OFF, the reading should be continuity. With the key switch ON, the reading should be no conti-
nuity. If either reading is incorrect, replace the key switch
(Figure 12-29, Page 12-28)
.
5. Connect wires to the key switch. Make sure wires are connected correctly and are tight. If they are not,
rewire or tighten as necessary.
6. Install dash panel in reverse order of removal.
Figure 12-28 Kill Limit Switch Test
1. 200 Ohm Setting 2. Lever Up
NO
COM
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
1
2
Summary of Contents for 2007 XRT 800
