Club Car 2007 XRT 800, Maintenance Service Manual, Page: 44 / 516

BODY AND TRIM Rear Body and Fenders – 800 and 810
Page 4-14 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
4
REAR FENDER REMOVAL
NOTE: The driver side rear fender can be removed without removing any other component, but the pas-
senger side rear fender cannot be removed without either removing the fuel tank or removing the
rear body. It is easier to remove the rear body than to remove the fuel tank.
1. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Driver side rear fender:
2.1. Remove the seat.
2.2. Raise the cargo bed.
2.3. Remove rear fender frame bolt (Figure 4-17, Page 4-14) .
2.4. Remove the top body and fender bolt.
2.5. Remove the two outside body and fender bolts and remove the fender from the vehicle.
3. Passenger side rear fender:
3.1. Remove the seat.
3.2. Remove the cargo bed. See Cargo Bed Removal on page 4-8.
3.3. Remove the seat back support brackets. See Seat Back Support Bracket Removal on
page 4-11.
3.4. Remove rear fender frame bolt.
3.5. Remove the rear body. See Rear Body Removal on page 4-12.
3.6. Place body and fender on a clean flat surface and remove the top body and fender bolt.
3.7. Remove the two outside body and fender bolts and separate the passenger side fender from the
rear body.
REAR FENDER INSTALLATION
NOTE: If both fenders have been removed, attach them to the rear body first, then install the rear body
with fenders attached.
Figure 4-17 Rear Fender Frame Bolts