![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829310.webp)
UNITIZED TRANSAXLE: 800/810 GASOLINE VEHICLES
Unitized Transaxle Removal
Page 18-6
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
18
5. Place a 1/4 to 3/8-inch (6-10 mm) diameter rod against the retaining ring and tap lightly at four to five
locations to ensure it is properly seated.
See following WARNING.
ý
WARNING
• Be sure bearing retaining ring is properly seated in its groove. If ring is not properly installed,
the axle assembly will separate from the transaxle and damage the axle assembly and other
components. Loss of vehicle control could result in severe personal injury or death.
UNITIZED TRANSAXLE REMOVAL
See General Warning on page 1-1.
1. Turn the key switch to the OFF position and remove the key, and place the Forward/Reverse handle in
the NEUTRAL position.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Close the fuel shut-off valve on fuel tank
(Figure 16-18, Page 16-25 or Figure 16-19, Page 16-25)
.
4. Detach all wires, hoses, etc. connecting the powertrain to the vehicle.
4.1. Disconnect the carburetor vent tube from the carburetor
(Figure 18-9, Page 18-7)
.
4.2. Disconnect the air intake hose from the carburetor
(Figure 18-10, Page 18-7).
Figure 18-7 Bearing and Collar
Figure 18-8 Axle Seal Tool
PRESS RAM
BEARING
PULLER
WEDGE
ATTACHMENT
BRAKE CLUSTER
REMOVED FOR CLARITY
AXLE SEAL
AXLE SEAL
TOOL
Summary of Contents for 2007 XRT 800
