UNITIZED TRANSAXLE: 850 GASOLINE VEHICLE
Axle Shaft
Page 19-4
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
19
ý
CAUTION
• Do not tighten the bearing puller wedge attachment against the axle shaft. This could damage
the axle shaft when pressing the bearing and collar off.
2. Press the bearing (71) and collar (73) off together
(Figure 19-6, Page 19-4).
See also
Figure 19-7,
Page 19-6
.
See following NOTE.
NOTE:
It may be necessary to heat the collar to remove it.
Do not remove the large axle retaining ring (70) from the axle
(Figure 19-6, Page 19-4)
. Since the
inner diameter of the retaining ring (70) is smaller than the outer diameter of the bearing (71), the
ring must be in place on the axle before a new bearing and collar are pressed on.
Figure 19-6 Differential Gear Case and Axle Tubes
74
73
70
71
74
73
70
68
76
75
67
70
71
73
74
72
71
72
Summary of Contents for 2007 XRT 800
