![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829334.webp)
UNITIZED TRANSAXLE: 850 GASOLINE VEHICLE
Unitized Transaxle Removal
Page 19-8
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
19
4.7. Loosen nuts securing shifter cable to shifter cable mounting bracket. Then disconnect the shifter
cable rod end from the shifter arm on the unitized transaxle and remove the cable from the cable
mounting bracket
(Figure 19-15, Page 19-8)
.
4.8. Mark for identification and then disconnect the 6-gauge white wire (F2 post), 6-gauge black ground
wire (A2 post), and 16-gauge yellow wire (DF post) from starter/generator
(Figure 19-16,
Page 19-8)
.
4.9. Disconnect the engine oil level sensor wire (18-gauge yellow) at the connector just to the rear of the
starter/generator)
(Figure 19-17, Page 19-9)
.
4.10. Disconnect the engine kill switch wire (18-gauge white/black) from the bullet connector at the lower
right front of the engine
(Figure 19-18, Page 19-9)
.
4.11. Cut away the wire ties securing the engine kill wire at the lower right front of the engine (below the
exhaust header), the wire harness at the governor cable bracket, and the wire harness to the plate
beneath the muffler.
Figure 19-13 Throttle Cable and Retaining Nuts (Top
View)
Figure 19-14 Engine Ground Wire and Retaining Nut
Figure 19-15 Shifter Cable (Top View)
Figure 19-16 Generator Wires
1. Loosen nuts. 2. Pull spring release back to remove shifter
cable from lever.
1. Yellow Wire 2. White Wire 3. Ground Wire at A2 Terminal
1
2
F2
DF
F2
1
2
3
Summary of Contents for 2007 XRT 800
