Club Car 2007 XRT 800, Maintenance Service Manual

Page: 245 / 516

ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE Key Switch
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual Page 14-13
14
2.2. Loosen, but do not remove, the screw (2) on each side of the center dash panel (3).
2.3. Insert screwdriver at the top center of the dash between dash and cowl brace. Gently pry center
dash out slightly from under edge of cowl brace.
2.4. Pull center dash out from the frame and disconnect the wires from the electrical components
mounted on the dash panel. Do not allow wires to touch. See following NOTE.
NOTE: Take care to prevent key switch terminals and wires from touching the metal frame around the
dash.
2.5. Slide center dash panel up the steering column.
3. Disconnect the wires from the key switch.
4. Remove the key switch:
4.1. Remove the key switch cap with a small, flat-blade screwdriver.
4.2. Remove key switch from the dash by holding the key switch and turning the nut on the outside of
the dash with a 1-inch socket wrench. Remove the keyed washer with key switch.
Key Switch Installation
1. Reverse removal procedures to install key switch in the dash. Connect wires to key switch. See Wiring
Diagram on page 12-6. Coat the connectors with Battery Terminal Protector Spray (CCI P/N 1014305)
to prevent corrosion. Be sure that key switch terminals cannot touch the frame and that panel is properly
seated and snapped in place.
2. Connect battery cables, positive (+) cable first, and tighten hardware to 144 in-lb (16 N·m) (Figure 1-1,
Page 1-3) . Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corro-
sion.
Figure 14-16 Center Dash Panel Removal
3
2
1