![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829280.webp)
FUEL SYSTEM: GASOLINE VEHICLE
Carburetor
Page 16-4
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
16
5. Remove the carburetor fuel bowl retaining screw and washer (12), then remove the fuel bowl (10) and
clean it with a nonflammable solvent
(Figure 16-4, Page 16-4)
.
See following NOTE.
NOTE:
Make sure the fuel bowl gasket (9) remains properly seated in the carburetor body when the fuel
bowl is removed
(Figure 16-4, Page 16-4)
.
During normal operation, the fuel bowl retains the float pivot pin (6). Make sure that the float pivot
pin does not fall out of the carburetor body after the fuel bowl is removed.
6. Remove the main jet (8) from the carburetor body and discard it
(Figure 16-4, Page 16-4)
.
See follow-
ing NOTE.
NOTE:
Make sure the fuel nozzle (7) does not fall out of the carburetor body after removal of the main jet.
This is best accomplished by positioning the carburetor upside down during main jet removal
(Figure 16-4, Page 16-4)
.
Figure 16-2 Drain Bowl
Figure 16-3 Mark Carburetor and Bowl for Alignment
Figure 16-4 Carburetor Components
1
2
3
4
5
7
8
6
9
11
12
10
Summary of Contents for 2007 XRT 800
