ELECTRICAL COMPONENTS: 850 GASOLINE VEHICLE
Fuel Gauge/Hour Meter
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 14-21
14
FUEL GAUGE/HOUR METER
See General Warning on page 1-1.
Testing the Fuel Gauge/Hour Meter
See Test Procedure 26 – Fuel Gauge on page 12-32.
See Test Procedure 27 – Hour Meter on page 12-33.
General Information
With the key switch in the OFF position, the fuel gauge field is blank; however, the hour meter field is always
ON. When the key switch is turned to ON, the fuel gauge field activates. The fuel gauge initially registers full
before indicating the actual fuel level.
The hour meter displays the number of hours of use in increments of 0.1 (one tenth) hour, but does not record
additional time unless the key switch is in the ON position and the engine is on. When recording, the hour-
glass icon blinks.
Fuel Gauge/Hour Meter Removal
1. Disconnect battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in Gen-
eral Warning on page 1-2.
2. Remove the center dash panel.
See Key Switch Removal on page 14-12.
3. Disconnect the wires from the fuel gauge/hour meter (1)
(Figure 14-22, Page 14-20)
. Do not allow wires
to touch.
4. Remove the mounting clip (2) that secures the gauge/meter. Alternate pulling the lower and upper tabs
away from the gauge housing to remove clip.
5. Pull gauge/meter from the instrument panel.
Fuel Gauge/Hour Meter Installation
1. Install a new fuel gauge/hour meter (1) into the hole in the instrument panel until the flange seats against
the instrument panel
(Figure 14-22, Page 14-20)
.
2. Force the mounting clip (2) onto the back of the fuel gauge/hour meter until fully seated.
3. Connect the wires to the fuel gauge/hour meter.
See Wiring Diagram on page 12-6.
4. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
5. Install the center dash in reverse order of removal. Be sure that key switch terminals cannot touch the
frame and that panel is properly seated and snapped in place.
6. Connect battery cables, positive (+) cable first, and tighten hardware to 144 in-lb (16 N·m)
(Figure 1-1,
Page 1-3)
. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corro-
sion.
Summary of Contents for 2007 XRT 800
