BODY AND TRIM
Rear Body and Fenders – 800 and 810
Page 4-12
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
4
2. Remove seat back support bolts and bed support weldment with bed bumpers from seat back supports
(Figure 4-13, Page 4-12)
.
3. Remove seat back support bolts from body and remove from vehicle
(Figure 4-14, Page 4-12)
.
SEAT BACK SUPPORT BRACKET INSTALLATION
1. Align passenger and driver side seat back support brackets with holes in body
(Figure 4-14, Page 4-12)
.
See following NOTE.
NOTE:
Striker plates should be to the outside of each bracket.
2. Install bracket bolts to body and tighten hardware to 14.5 ft-lb (19.6 N·m).
3. Position bed support with bumpers onto seat back supports and frame
(Figure 4-13, Page 4-12)
.
4. Install bracket and bed support bolts to frame and tighten to 100 in-lb (11.3 N·m).
REAR BODY AND FENDERS – 800 AND 810
See General Warning on page 1-1.
NOTE:
The driver side rear fender can be removed without removing any other component, but the pas-
senger side rear fender cannot be removed without either removing the fuel tank or removing the
rear body. It is easier to remove the rear body than to remove the fuel tank.
REAR BODY REMOVAL
1. Remove the seat from the rear body.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
Remove cargo bed.
See Cargo Bed Removal on page 4-8.
3. Remove seat back support brackets.
See Seat Back Support Bracket Removal on page 4-11.
4. Remove the two screws, nuts and washers located at the bottom edge of the seat support panel (in kick-
plate just above the floormat)
(Figure 4-15, Page 4-13)
.
Figure 4-13 Seat Weldment Support
Figure 4-14 Seat Back Body Support
Summary of Contents for 2007 XRT 800
