UNITIZED TRANSAXLE: 850 GASOLINE VEHICLE
Unitized Transaxle Installation
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 19-17
19
22. Position the shifter cable in the shifter cable mounting bracket on the engine and tighten the mounting
nuts to 22 ft-lb (29.8 N·m). Connect shifter cable rod end to the shifter arm
(Figure 19-45, Page 19-17)
.
23. Attach the ground wire to the mounting screw on the oil filler tube mounting bracket and tighten to 50 in-
lb (5.7 N·m)
(Figure 19-46, Page 19-17)
.
24. Connect accelerator cable to actuator cam in the electrical box. Position the accelerator cable in the
mounting slot in the wall of the electrical box and tighten mounting nuts to 18 in-lb (2.0 N·m)
(Figure 19-47, Page 19-17)
. Install electrical box cover and tighten mounting screw.
25. Remove the 1/4-inch bolt from the fuel line and connect the fuel line to the carburetor and secure with
a hose clamp
(Figure 19-48, Page 19-17)
.
26. Connect the impulse line to the fuel pump and secure it with the hose clamp
(Figure 19-49, Page 19-18)
.
27. Connect air intake hose to carburetor and secure hose clamp
(Figure 19-50, Page 19-18)
.
Figure 19-45 Shifter Cable (Top View)
Figure 19-46 Engine Ground and Retaining Nut
1. Nuts. 2. Pull spring release back to connect shifter cable to
lever.
Figure 19-47 Connect Cable to Cam and Secure with
Retaining Nuts
Figure 19-48 Connect Fuel Line
1
2
Club Car
RETAINING NUTS
TOP VIEW
Summary of Contents for 2007 XRT 800
