ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group Adjustment – Gasoline Vehicle
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 5-11
5
PEDAL GROUP ADJUSTMENT – GASOLINE VEHICLE
See General Warning on page 1-1.
1. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
2. Adjust brake pedal height.
2.1. Chock wheels and release park brake. Lift rear of vehicle and place jack stands under the axle
tubes to support the vehicle.
2.2. To provide slack in the brake cables, loosen the equalizer retaining nuts (2 and 3) on the equalizer
rods (1)
(Figure 5-9, Page 5-11)
.
2.3. Loosen the brake stop jam nut (31), then relieve pedal pressure on the stop by pushing down
slightly on the pedal. Next, adjust the brake stop bumper (22) up or down
(Figure 5-10, Page 5-11)
.
Adjusting the bumper upward decreases distance between pedal and floorboard. Adjusting the
bumper downward increases distance between pedal and floorboard. Proper brake pedal height is
6 inches (15.2 cm)
(Figure 5-11, Page 5-11)
.
2.4. Tighten the jam nut (31) to 8 ft-lb (9.5 N·m)
(Figure 5-10, Page 5-11)
.
Figure 5-9 Loosen Rear Brake Equalizer Rod Nuts
Figure 5-10 Brake Pedal Height Adjustment
Figure 5-11 Brake Pedal Height Measurement
1
2
3
22
31
PA
RK
ST
OP
1 2
3
4
5
6
7
8
9
10 11
12
Correct pedal position
is 6 inches (15.2 cm)
from floor mat to back
of brake pedal.
Summary of Contents for 2007 XRT 800
