Club Car 2007 XRT 800, Maintenance Service Manual

Page: 319 / 516

UNITIZED TRANSAXLE: 800/810 GASOLINE VEHICLES Unitized Transaxle Installation
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual Page 18-15
18
12. Remove the blocks from under the engine and roll the powertrain into position under the vehicle. Then
lift the front of the powertrain and place the snubber into the snubber bracket in the vehicle frame
(Figure 18-39, Page 18-15) .
13. Position the floor jack under the rear frame crossmember and raise the jack high enough to support the vehi-
cle (Figure 18-40, Page 18-15) . Make sure the vehicle is stable on the jack, then remove the jack stands.
14. After the jack stands are removed, lower the vehicle to approximately its normal height. Position the leaf
springs in the front spring mounts and install the bolts and lock nuts. Tighten to 15 ft-lb (20.3 N·m).
15. Adjust the vehicle height with the floor jack to position the leaf springs for mounting in the shackles. Install
the mounting bolts, and lock nuts (Figure 18-41, Page 18-15) .
Figure 18-38 Driven Clutch Figure 18-39 Snubber
Figure 18-40 Leaf Springs Figure 18-41 Leaf Springs and Shackles
KEY
SNUBBER
BRACKET
SNUBBER