Club Car 2007 XRT 800, Maintenance Service Manual

Page: 490 / 516

TRANSAXLE (TYPE G): ELECTRIC VEHICLE Axle Bearing and Shaft
Page 28-2 2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
28
4. Use 90° internal snap ring pliers to remove the internal retaining ring (6) from the axle tube. (Figure 28-1,
Page 28-2) . See also Figure 28-1, Page 28-2 .
5. Remove the axle, retaining ring, and bearing assembly by pulling the axle straight out of the housing.
6. If necessary, remove the axle oil seal (15) and adapter ring (39) (Figure 28-5, Page 28-3) .
6.1. Use a bearing puller (CCI P/N 1016417) to remove the axle seal and adapter ring from the axle tube
(Figure 28-2, Page 28-2) . See following CAUTION and NOTE.
CAUT ION
• Do not scar or damage the inside surfaces of the tube when removing the oil seal and adapter
ring. A damaged tube might have to be replaced.
NOTE: Do not discard the adapter ring. If the adapter ring is lost or damaged, the axle tube will have to be
replaced.
6.2. Use a press to separate the axle oil seal (15) from the adapter ring (39) (Figure 28-3, Page 28-2) .
Retain the adapter ring and discard the oil seal.
7. Inspect the axle shaft assembly to be sure the bearing and collar have not slipped and are still seated
against the shoulder on the axle shaft.
8. Inspect bearing (5) (Figure 28-5, Page 28-3) . If the bearing in a Type G transaxle is worn or damaged,
the entire axle shaft assembly (1 or 2) must be replaced.
Figure 28-1 Axle Tube Figure 28-2 Axle Seal and Adapter Ring Removal
Figure 28-3 Axle Seal and Adapter Ring Figure 28-4 Axle Seal and Adapter Ring Installation
15
39
1