ELECTRICAL COMPONENTS: 800 AND 810 GASOLINE VEHICLES
Reverse Warning Buzzer
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 13-19
13
REVERSE WARNING BUZZER
See General Warning on page 1-1.
Testing the Reverse Warning Buzzer
See Test Procedure 20, Section 11, Page 11-30.
Reverse Warning Buzzer Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect the battery cables as instructed.
See WARNING “To avoid unintentionally starting...” in
General Warning on page 1-2.
3. Remove the instrument panel.
See Key Switch Removal on page 13-14.
4. Disconnect the wires from the reverse warning buzzer (2)
(Figure 13-21, Page 13-19)
.
5. Remove the screw (3), nut (4), lockwasher (5) and flat washer (6) securing the buzzer to the vertical
frame support.
Reverse Warning Buzzer Installation
1. Install the screw (3) through the buzzer (2) bracket tab and frame, secure with hardware, and tighten to
14 in-lb (1.6 N·m)
(Figure 13-21, Page 13-19)
.
See following NOTE.
NOTE:
The reverse warning buzzer is secured at one hole only.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Install the dash in reverse order of removal.
See Key Switch Removal on page 13-14.
5. Connect battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16.3 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
Figure 13-21 Front Reverse Warning Buzzer
BLACK GROUND
RED/WHITE
2
3
4
5
6
Summary of Contents for 2007 XRT 800
