![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829355.webp)
TORQUE CONVERTER: GASOLINE VEHICLE
Drive Clutch
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 20-7
20
DRIVE CLUTCH DISASSEMBLY
ý
CAUTION
• The drive clutch is balanced as an assembly. Before disassembly, make match marks on the
drive clutch hub and on the moveable face assembly so they can be reassembled in the same
positions (Figure 20-6, Page 20-7).
1. Make match marks on the drive clutch hub and on the moveable face casting
(Figure 20-6, Page 20-7)
.
2. Remove the drive clutch hub (1)
(Figure 20-5, Page 20-6)
:
2.1. Remove the three plugs (22) from the clutch puller attachment holes
(Figure 20-5, Page 20-6)
.
2.2. Thread the center bolt of the Drive Clutch Hub Puller (CCI P/N 1014497) into clutch until the stop
nut touches the clutch, then back the bolt out one-half turn
(Figure 20-7, Page 20-7)
.
2.3. Thread the three small bolts of the puller into corresponding holes in the clutch. Tighten bolts
evenly, making sure the face of the puller plate is parallel to the face of the clutch
(Figure 20-7,
Page 20-7)
.
2.4. Unscrew the puller center bolt out of the clutch to pull drive clutch hub off.
3. Remove the thrust washer (11) from the moveable face (14)
(Figure 20-5, Page 20-6)
.
4. Remove the drive buttons
(Figure 20-8, Page 20-8)
.
4.1. Remove the screws, flat washers, drive button take-up springs, and drive buttons as shown
(Figure 20-8, Page 20-8)
.
Figure 20-6 Mark Drive Clutch Hub
Figure 20-7 Remove Drive Clutch Hub
DRIVE CLUTCH
HUB PULLER
TOOL
(CCI P/N 1014497)
Summary of Contents for 2007 XRT 800
