![background image](http://html1.mh-extra.com/html/club-car/2007-xrt-800/2007-xrt-800_maintenance-service-manual_2626829481.webp)
MOTOR (MODEL EJ4-4001)
Motor Component Testing and Inspection
2007-2008 XRT 800, 810 and 850 Maintenance and Service Manual
Page 27-9
27
Terminal Insulator Inspection
1. Remove the motor from the vehicle.
See Motor Removal, Section 27, Page 27-2.
2. Remove the terminal insulators by performing steps 1 through 12 of Motor Disassembly on page 27-4.
1. Inspect the insulators (4 and 6) for cracks or other damage
(Figure 27-15, Page 27-10)
. Replace insu-
lators as required.
Bearing Inspection
NOTE:
Replacement of the end cap bearing is highly-recommended if the end cap is removed from the
motor. The following procedure is provided as a guideline for determining general bearing failure.
1. Remove the motor from the vehicle.
See Motor Removal, Section 27, Page 27-2.
2. Remove the bearing by performing steps 1 through 14 of Motor Disassembly on page 27-4.
3. Use a clean cloth to wipe the carbon dust off of the bearing. Inspect the bearing by spinning it by hand
and checking for both axial (A) and radial (B) play
(Figure 27-14, Page 27-9)
.
4. Replace the bearing if it is noisy, does not spin smoothly, or has excessive play. Check the bearing and
replace if rusted, worn, cracked, or if there is an abnormal color change in the metal of the bearing.
Speed Sensor Magnet Inspection
Inspect the speed sensor magnet (24) for rust, wear, and cracks
(Figure 27-15, Page 27-10)
. Replace the
magnet if necessary.
Figure 27-13 Brush Spring Tension Test
Figure 27-14 Bearing Inspection
C-SHAPED
STEEL PLATE
SCALE
A
B
Summary of Contents for 2007 XRT 800
